Hubbell 1-Punch Jack Termination Tool

Product Description

Hubbell 1-Punch Jack Termination Tool Saves Time

The Hubbell 1-punch jack termination tool has been specifically designed to work with Hubbell’s Cat6 (HXJ / XJ) and Cat6A (HJ) jacks. Its unique design enables all four pairs to be punched down and trimmed in “one punch” drastically saving the amount of time required to terminate individual jacks. The 1-Punch consists of the punch handle with individual heads available to work with Hubbell’s Cat6 or Cat6A jacks. During the installation process the jack needs to be held in place via the Hubbell hand termination aid or the jack knuckles termination aid.

Installation Operation
The installation process using the 1-Punch termination tool can be achieved in five simple steps:

1. Lace Jack

Lace the jack and place in a Hubbell termination aid. Always use this tool with a termination aid.

2. Align The Head

Align the head of the punch-down tool over the target jack with the slots of the tool head ready to slide onto the shoulder of the jack nose.

3. Placing The Punch

Place the punch-down head onto the Hubbell jack.

4. Punch Down

With one hand, hold the termination aid. With the other, press the handle completely down until the tool cycles impact.

5. Remove Jack

Remove the tool head from the jack and inspect the jack. Install stuffer cap onto the termination towers.